(2) ADAPT-Floor Pro accounts for axial shortening of columns. Note that the spring should replace the physical member (i.e. (1) Apply a point spring with a given stiffness at the location of support. To change this, select the desired reinforcement and from the “Modify Item Properties” input, go to the “Rebar” tab and change the bar distribution to grouped.Ĭan applied displacements be applied in ADAPT-Floor Pro?Īpplied displacements cannot be explicitly applied in the program, however, there are two methods whereby this behavior can be modeled. When working in ADAPT-Floor Pro RC or MAT-RC, the program will automaticlly distribute all calculated reinforcement over the tributary width. How can I make the program calculated top reinforcement “grouped” rebar centered over the support instead of “distributed” over the tributary width? Can Floor Pro and MAT run an unlimited number of load combinations?įor punching shear check, the program can run up to 50 strength combinations.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
May 2023
Categories |